and anticlockwise decreases the value. After setting the desired value press and hold the SET key
until the Data Group number is shown on the right hand side of the screen. The data value is now
saved to the indicated Data Group number. Pressing the set key again returns to the Data Group
menu options. Repeat the above process for changing any of the other numerical values for the
selected Data Group. To exit the Data Group menu press the set key again.
Selected Data Group output state at power on
Press V/↑or A/↓to step up or down through the menu options to select S-INI and then press
the rotary control to allow modification of the S-INI option. Turn the rotary control to select
either ON or OFF. Selecting ON means the device will Power on with the Output enabled.
Selecting OFF means the device will Power on with the Output disabled. After selecting the
desired setting press and hold the SET key until the Data Group number is shown on the right
hand side of the screen. The data value is now saved. Pressing the set key again returns to the
Data Group menu options. To exit the Data Group menu press the set key again.
Other functions
Enable or Disable the Output.
At any time you can press the ON/OFF key to enable or disable the Output.
Locking the keypad to avoid accidental operation.
The keypad operation can be disabled to avoid accidental operation and unwanted changes. At
any time you can simply press and hold the rotary control for more than 3 seconds to either lock
or unlock all keys. The status of the key lock will be displayed at all times via the lock icon on the
right side of the screen. Keypad locked is indicated by a closed padlock. Keypad unlocked is
indicated by an open padlock.
M0-M9 Data Groups
M0 Data Group
The M0 Data Group is a special case. It is the power default Data Group. It should be noted that
any time an alternative Data Group is selected or any changes made to the existing settings then
M0 will be immediately overwritten with the newly selected data. In effect, M0 is always a
real-time duplicate of the currently selected Data Group and data values. It is also the data-set
that will be saved at power off and recalled at next power on. This happens automatically and
transparently with no input necessary from the user.
Shortcut keys to select and recall M1 or M2 Data Group
From the main interface, press and hold V/↑or A/↓for more than 3 seconds to quickly recall the
M1 or M2 Data Group. The corresponding Data Group number will displayed on the right of the
screen. The M1 and M2 Data Groups are ideal choices for commonly used settings due to the
quick recall function.
Select and recall any specific Data Group.
To Next Page
Loading...
Need help?
General
