Web-based Configuration Guide Network Settings
3.1.2 Setting the Address of a LAN Port for a Single Online Bridge
Choose Overview > WDS Group Info > NVR (AP)/Camera (CPE).
To set the IP address for a single device, click , and select LAN from the drop-down list. For the configuration
method, see Allocating IP Addresses to All Bridges in the Network.
Caution
After the IP address and subnet mask are changed, the device web page may not be accessed. You need to
enter the new IP address in the browser address bar and ensure that the IP addresses of the management
computer and the device are in the same network segment. If they are not in the same network segment,
reconfigure the IP address of the management computer. (See Configuring the IP Address of the Management
Computer) Therefore, exercise caution when performing this operation.
To Next Page
Loading...
