Reyee Series Implementation Cookbook
Configuration Key Points
1. Configure router A in the HQ as the IPsec server.
2. Configure router B in the branch as the IPsec client.
3. Keep parameter settings at both ends consistent. The parameter settings in this case are as follows:
Authentication mode: pre-shared key, with the key set to ruijie.
IKE algorithm: 3DES-MD5, DH2
IPsec negotiation scheme: ESP(3DES-MD5)
Configuration Steps
Step 1: Configure the HQ router. Choose Gateway → VPN → IPSec → Add to add a policy.
Routers in the HQ and branch
both use static IP addresses
To Next Page
