Reyee Series Implementation Cookbook
5.3 Smart Flow Control
Reyee Smart Flow Control is a feature used to avoid congestion by optimizing user traffic. The working principle is shown as
below: when the total user traffic is low than the maximum WAN bandwidth, the rate limit policy will not be applied, every user
will get the required bandwidth; However, when the total user traffic exceeds the maximum WAN bandwidth, the user-based
rate limit will take effect. The total WAN bandwidth will be equally allocated to every user. For example, If there are 10 users in
the network, the total user traffic is 200Mbps and WAN bandwidth is 100Mbps, every user will get 10Mbps bandwidth after
enabling the smart flow control feature.
Configuration Steps
Step 1: Choose Gateway → Advanced → Flow Control and enable the feature.
To Next Page
Loading...
