Ruijie RG-S5000-24GT4MS-E - Page 17

Hardware Installation and Reference Guide Product Overview
14
You can press the port LED mode switching button (PoE button) to switch the port status indicator function (port PoE
power supply indicator and port rate indicator). Hold down the button for more than 2 seconds to ensure successful
switching.
Back Panel
Figure 1-19 Back Panel of RG-S5000-10GT2MS-P-E Switch
Description:
1. Grounding stud
2. Power cord retention clip hole
3. Power plug
Power Supply
The RG-S5000-10GT2MS-P-E switch adopts an AC power supply.
 AC input:
Rated voltage range: 100 V AC to 240 V AC; 50 Hz/60 Hz
Maximum voltage range: 90 V AC to 264 V AC; 47 Hz to 63 Hz
Frequency: 50 Hz/60 Hz
Rated current: 3 A
Power cord requirements: 10 A power cord
Heat Dissipation
The RG-S5000-10GT2MS-P-E switch adopts the ventilation mode of air inlet from the left and right sides and air outlet
through the rear side to ensure that the device works properly under specified environment. When placing a chassis,
maintain a minimum clearance of 10 cm (3.94 in.) on both sides and around the back panel of the chassis for air
circulation. Dust the device every three months to avoid blocking the ventilation openings on the housing.
Figure 1-20 Airflow Direction of RG-S5000-10GT2MS-P-E Switch