TECHNICAL MANUAL FOR THE RDR BL3 - V1.1 DRIVE ROLLER Rev. 21/09/2018 page 36
14 ADDITIONAL CABLE
In addition to the BL3 drive roller is possible request the following type of wiring cable:
1) Male to female M8 5 pin wire extension for RDR BL3 length = 2000 mm ordering code: RDRELT_00035;
it allows to extend the BL3 drive roller power/command cable length in order to reach the maximum length
of 2600 mm
2) Male to female M8 5 pin wire extension for RDR BL3 length = 5000 mm ordering code: RDRELT_00036;
it allows to extend the BL3 drive roller power/command cable length in order to reach the maximum length
of 5600 mm
3) Male to 2 female M8 5 pin splitter for RDR BL3 length=250+1000 mm ordering code: RDRELT_00032; it
allows the connection of two BL3 drive roller to a single RMC control board.
Caution: using the splitter cable the fault signal is not correctly reported.
4) Naked wire to female M8 5 pin adaptor cable for RDR BL3 L=500 mm ordering code RDRELT_00034; it
allows to connect with 5 pre-tinned naked cables the BL3 with a large amount of command and power
circuit: Caution: using this adaptor cable check the following table for wire connection
To Next Page
Loading...
General