Need help?Do you have a question about the RunCam HD and is the answer not in the manual?
Turns the camera ON/OFF. In Playback Mode, selects video files.
Starts/stops recording, takes snapshots. In Playback Mode, plays/stops playback.
Switches camera working modes. Used to format the TF card.
Restores the camera to factory settings.
Connect to 5V DC supply via USB. Indicator A shows charging status (Green).
Details the function of Indicator A (mode/status) and Indicator B (auxiliary status).
Serves for power charging, data transmission, and video output.
Press Power Button for 1 second. Indicator A changes to Yellow, entering Video Mode 1 Standby.
Explains Video Modes 1 (Yellow), 2 (Blue), Photo Mode (Red), and Playback Mode. Use Mode Button to cycle.
Details Indicator A status for recording (Yellow/Blue flicker) and taking photos (Red flash).
Camera auto-shuts down after 30 seconds of inactivity in Standby mode.
Long-press Mode Button for 10 seconds to format. Indicator A turns Red and flickers.
Connect TV-out cable for continuous AV signal. Mode active only when cable is connected.
In Standby (no AV cable), camera auto-shuts down after 30 seconds of inactivity.
Press Reset Button while camera is on to restore factory settings.
Press Power Button for 1 second. Indicator A blinks Red, then camera shuts down.
Use USB cable as storage device. Read/write files on TF card when camera is off or in Standby.
General| Video Resolution | 1080p |
|---|---|
| Video Frame Rate | 30fps |
| Video Format | MOV |
| Image Format | JPEG |
| Memory Card Type | microSD |
| Sensor | CMOS |
| Power Supply | 5V USB |
| Storage | Up to 32GB |
| Battery | 850mAh |
To Next Page
