6
7
●
●
●
Indicator A illuminating a constant Green light:
the battery is charging.
When the camera is turned on, and the
Indicator A quickly flickers a Yellow light: there is
no memory card detected or the memory card is
invalid. Please format the memory card or change
a new card. (About formatting, please refer to
following “Format the Memory Card” chapters).
Indicator A quickly flickers a Red light during
video recording: the battery is low and the
camera will turn off automatically in several
seconds.
Playback:
● In Standby status (without connected the AV
output cable), the camera will automatically
shut down if there are not any operations
selected within 30 seconds.
Note: This mode will be effective only when the
TV output cable is connected to the camera.
Power-Saving Mode:
● In Standby status, the camera will automatically
shut down if there are not any operations selected
within 30 seconds.
Format the Memory Card:
● In any mode, long-press the Mode Button for
about 10 seconds to format the memory card.
The Indicator A light will turn Red and quickly
flicker Three times when the camera starts to
format the memory card. The camera will
automatically shut down after the formatting is
finished.
AV Output:
Turn the camera on, and connect the TV-out
cable to the camera, then the camera is in the AV
output status. In this status, the camera will
continuously outputs the AV signal. It won't shut
down even without video recording or snapshot.
Note:
● Make sure there are no important files saved
on the c ard b e for e form a ttin g i t. Afte r
formatting, all files will be deleted.
● This camera cannot support any memory card
formatted by a computer running Win XP.
Please use the formatting function of this
camera to format the memory card.
To Next Page
Loading...
