MODEL F73（17603）
13
Flash, enter program set mode. Press or to adjust values.
D. Manu/Confirm button
In menu mode, press and light on, then enter program display
mode, viewing all values.
In program display mode, press and light on, then enter
program set mode, adjusting all values.
Press after all program are set, and then the voice “Di” means all
settings are success and return program display mode.
E. Manual/Return button
Press in any status, it can proceed to next step. (For example:
When outlet water is unqualified, after unlock buttons, press to
end service, start a regeneration. During regeneration cycyles, press
to end one cycle and start next cycle.)
Press in program display mode, and it will return in Service; Press
in program set mode, and it will return program display mode.
Press while adjusting the value, then it will return program display
mode directly without saving value.
F. Down▼ and Up▲
In program display mode, press ▲ or ▼ to view all values.
In program set mode, press ▲ or ▼ to adjust values.
Press and hold both ▲ and ▼ for 5 seconds to lift the Button Lock
status.
To Next Page
Loading...
