Runxin 63610 User Manual

MODEL: N74A1-63510/N74A3-63610/N74B1-63510B/N74B3-63610B
12
 Light on，enter program display mode. Use or to view all
values.
 Flash enter program set mode. Press or to adjust values.
D. Manu/Confirm button
 Press , light on, enter program display mode and use or to
view all values.
 In program display mode, press , flash, enter program set mode,
press or and adjust values.
 Press after all program are set, and then the voice “Di” means all
setting are success and return program display mode.
E. Manual/Return button
 Press in any status, it can proceed to next step. (Example: Press
in Service status, it will start regeneration cycles instantly; Press
while it is in Backwash status, it will end backwash and go to Brine &
Slow Rinse at once.)
 Press in program display mode, and it will return in Service; Press
in program set mode, and it will return program display mode.
 Press while adjusting the value, then it will return program display
mode directly without saving value.
F. Down ▼ and Up ▲
 In program display mode, press ▲ or ▼ to view all values.
 In program set mode, press ▲ or ▼ to adjust values.
 Press and hold both ▲ and ▼ for 5 seconds to lift the Button Lock status.

Runxin 63610 Specifications

General

Brand	Runxin
Model	63610
Category	Control Unit
Language	English