FILLING OR RE-FILLING THE WATER RESERVOIR
Before using this appliance for the first time or after long periods of not operating the appliance, the
machine must be rinsed out. This short procedure will rinse and clean the internal piping
thoroughly.
First note that there are two ways to fill the water reservoir: directly into the water reservoir by
using for example a jug or by removing the water reservoir from the appliance.
Filling without removing the water reservoir:
Lift the water reservoir lid
Fill the water reservoir up to the “MAX” level
mark with cold fresh water (the maximum
capacity is 0.8 litre), or fill at least the “MIN” level
mark as shown in figure 1.
Lower and close the water reservoir lid