Russell Hobbs RHRV200 R-VAC PET - Page 16

16
CLEANING THE DUST BIN:
1. Remove the dust bin.
2. Press the two side clips (see Figure 1) on the dust
bin to release the gate.
3. Push the gate open and pour out the dust.
4. Push on the rubber strip to open the clear cover.
Pour out the dust.
5. If required, dust the insides of the bin with the brush
(see Figure 2).
CLEANING THE FILTER:
IMPORTANT: Do not allow water near the fan assembly.
1. Liftuptheclearcover,takeoutthelter(seeFigure3),andthencleanthedustbin.
2. Useahairdryerwithcoldairtocleanthelter(seeFigure4),anddustcleanwiththe
dust brush (see Figure 5).
Slide Clip
Clear cover
Rubber cleaning head
Figure 2
Figure 4
Figure 5
Figure 1
take out
Figure 1 Figure 2
Figure 2
Figure 4
Figure 5
Figure 1
take out
Figure 4 Figure 5
Figure 3