BA.GB.12-27409-05-07-FTA-jr
6.5 Operating the Steiger
Pre-condition:
Putting the Ruthmann-Steiger into operation acc. to chapter 5,
vehicle engine started and operating pressure of the compressed-
air system (if provided) built up,
hydraulic pump drive switched-on,
control stand „Cage control“ switched-on.
In the control stand selection „Cage control“ all Steiger movements are
controlled over the operating panel of the working cage.
Note
All operational movements of the Ruthmann-Steiger are only
possible with running vehicle engine. The ignition and the
hydraulic pump drive (power take-off) must be kept switched
on during the whole Steiger operation.
Danger!
It is not allowed to stay in the driver's cab if the front
axle is lifted! It is not allowed to put additional load into
the driver's cab. It is also not allowed to mount addi-
tional load, fittings or pieces on the driver's cab! It is not
allowed to use the front accesses!
To Next Page
Loading...
