BA.GB.12-27409-05-07-FTA-jr
6.5.2 Handling of the operating panel in the working cage
6.5.2.1 Leather covering (Optional extra)
A heat-resistant leather covering is installed on the switch box of the work-
ing cage for protection. For operation it is folded upwards. For this the plas-
tic snap locks must be pulled to the side up to the engaging point. Do not
pull out completely. Then the cover can be folded upwards.
Note
We recommend closing the cover again for protection after
finishing the work and leaving the working cage.
6.5.2.2 Switch off or start vehicle engine
Execution at operating panel
actuate push button „Stop“
or
Actuate push button „Start“
Note
For switching off or starting the vehicle engine keep the push
button as long depressed until the engine has stopped or
started respectively. When the vehicle engine has been
turned off, it must not be restarted for a short period of a few
seconds. When the vehicle engine has been turned off, it
cannot be started from the operation panel of the working
cage using the „Start“ push button with shifted gear and/or
the parking brake has not been set.
To Next Page
Loading...
