RUTHMANN Steiger TB270 - Page 179

8 Rectification of
malfunctions
BA.GB.12-27409-05-07-FTA-jr
RUTHMANN-Steiger
®
TB270
8-7
8.3 Reading of fault memory
Note
If with blinking pilot lamp „Bridge safety cut-out“ no re-
striction of the driving operation is determined, you should,
however, read out the fault memory and notify the Ruth-
mann-after-sales-service if necessary.
The faults are stored with date and time of their occurrence. The fault
memory can be read out at any time, not only by the after-sales-service,
but also from the operator.
Plain text indication
Execution
Depress push button „page up“
as often as the corresponding display page ap-
pears
x Read out fault memory?
Yes = Special Funct.
Depress push button „Special function“
Number of fault messages
stored.
Depress push button „Special function“
Latest fault message
stored.
Depress push button „Special function“
Fault message before the
last.
Depress push button „Special function“
etc.
Leaving the programme
fault message stored
Depress push button „page up“
following display pages
or
fault messages stored
Depress push button „Display down“
previous display pages
The display firstly shows the number of fault messages stored. With each
further depressing the push button „Special function“ the fault messages
stored appears in the reverse sequence as they appeared. So the last fault
message appears at first and the oldest message last. The contents of the