EasyManua.ls Logo

RW Flame RFH-6001LH - User Manual

Default Icon
27 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Electric Fireplace
RFH-3001LA(B) / RFH-3601LA(B) / RFH-4001LA(B) / RFH-4201LA(B) /
RFH-4801LA(B) / RFH-5001LA(B) / RFH-6001LA(B/H) / RFH-7401LA(B) / RFH-10201LA(B)
NO VENTING REQUIRED
WARNING
Read and understand this entire owner's manual, including all safety information
before plugging in or using this appliance. Failure to do so could result in fire, electric
shock, or serious personal injury.
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS: ETL
IMPORTANT INSTRUCTIONS
AND OPERATING MANUAL
9733 Topanga Canyon Blvd. APT310, Chatsworth, CA 91311
Phone: 213-4467172

Table of Contents

Questions and Answers

  • M
    Monica KramerAug 15, 2025
    Why won't the heater on my RW Flame RFH-6001LH Indoor Fireplace turn on with the power switch?
    • S
      stephaniejuarezAug 15, 2025
      The heater might not be turning on for several reasons. First, ensure the main power supply switch is in the "ON" position. Check if the circuit breaker has tripped, indicating too many appliances on the circuit; this unit should have its own individual circuit. Verify the power cord is securely plugged into a functioning and properly grounded 15 Amp 120V AC electrical outlet. Also, the power cord or plug could be damaged, requiring a qualified electrician to replace the cord. The power outlet might be loose and need replacement, or there could be loose wiring requiring inspection and repair by a qualified electrician.
  • J
    Jenna WhiteAug 18, 2025
    What to do if my RW Flame Indoor Fireplace heater system doesn't come on?
    • T
      Tanya ParkAug 18, 2025
      If the heater system isn't turning on, first ensure the heater power switch is in the "ON" position. The system may have overheated; if so, it might be covered, or the air inlet/outlet could be blocked. Remove any obstructions, turn off the power switch, unplug the unit, wait 10 minutes, and then try turning it on again. Also, check for loose wiring, which should be inspected by a qualified electrician. Ensure there is adequate space around the unit and remove any blockages from the air inlet or outlet.
  • B
    Bailey WilliamsAug 21, 2025
    Why is there no airflow from my RW Flame RFH-6001LH Indoor Fireplace when the 'HEAT' switch is on?
    • J
      Jessica FernandezAug 21, 2025
      If there's no airflow when the 'HEAT' switch is on, the heater system may be overheated, causing the temperature limit thermostat to cut off. Check the air inlet and outlet, then turn off the power switch, unplug the unit, wait 10 minutes, and turn it back on. Also, make sure both the 'POWER' and 'HEAT' switches are turned on.
  • K
    kellyamyAug 25, 2025
    How to fix a RW Flame RFH-6001LH Indoor Fireplace with heater on, but no flame or low flame intensity?
    • J
      Joshua FarrellAug 25, 2025
      If the heater is on but the flame is missing or weak, try long-pressing the "DIMMER" button for 6 seconds to ensure the appliance is not in sleep mode (all lights off, heating on). Press and hold again for 6 seconds to return to normal mode. Also, check that the Flame Adjusting knob is set to the maximum. Finally, loose wiring could be the issue, so consult a qualified electrician to check all wiring connections.
  • K
    kevinmurrayAug 28, 2025
    What to do if my RW Flame RFH-6001LH has a sudden power outage during heating?
    • H
      Heather HartAug 28, 2025
      If you experience a sudden power outage during the heating process, make sure you are not covering the air outlet. Unplug the unit, wait 10 minutes, and then try turning it on again.
  • J
    Jennifer NelsonAug 31, 2025
    How do I fix my RW Flame Indoor Fireplace remote control if it's not working?
    • K
      Kyle JacksonAug 31, 2025
      If the remote control isn't working, first ensure the battery is correctly installed and that you've removed the transparent insulating piece. Aim the remote control directly at the receiver. Remove any obstacles between the remote and the machine that may be blocking the signal. Finally, avoid pressing the remote control buttons too quickly; allow the unit time to respond to each command.
  • R
    Robert BowersSep 4, 2025
    What to do if the control panel functions on my RW Flame Indoor Fireplace do not work?
    • H
      Hannah AnthonySep 4, 2025
      If the control panel functions aren't working, first ensure the Power Switch on the control panel is turned on. Also, make sure you have reconnected the data cable which was pulled out when you removed the glass frame.
  • F
    fullerandrewSep 7, 2025
    How to remove the mounting bracket from RW Flame Indoor Fireplace?
    • J
      Jonathan RamirezSep 7, 2025
      To remove the mounting bracket, unscrew the two screws on both sides of the fireplace using a Phillips screwdriver, then remove the pre-attached mounting bracket.
  • B
    beanrubenSep 10, 2025
    Why is there an odor coming from my RW Flame Indoor Fireplace heater?
    • R
      Rhonda RogersSep 12, 2025
      The heater may emit a slight, harmless odor when first used. This is normal due to the initial heating of internal parts and will not occur again.

Summary

IMPORTANT SAFETY INSTRUCTIONS

1.0 PACKING LIST

1.1 DIMENSIONS

2.0 ELECTRICAL INSTALLATION NOTES

2.1 GENERAL INSTRUCTIONS

Essential electrical setup and safety advice before operation.

3.0 INSTALLATION INSTRUCTIONS

3.1 UNPACKING AND TESTING APPLIANCE WALL

Procedures for unpacking and initial testing of the fireplace.

3.2 GROUNDING APPLIANCE

Detailed steps for ensuring the appliance is properly grounded.

3.3 ASSEMBLY

Options and steps for physically assembling the fireplace unit.

4.0 FINISHING

5.0 OPERATING INSTRUCTIONS

5.1 MAIN POWER BUTTON

Identifies and explains the main power button's function.

5.2 CONTROL PANEL; REMOTE CONTROL OPERATION

Guide to using the appliance's control panel and remote.

5.3 REMOTE CONTROL

Specific instructions for operating the fireplace using the remote.

6.0 TROUBLE SHOOTING GUIDE

7.0 MAINTENANCE

7.1 PARTIALLY REFLECTIVE GLASS CLEANING

How to clean the fireplace's glass surface without damage.

7.2 SCHEMATIC DIAGRAM

Provides the electrical circuit diagram for technical reference.

8.0 LIMITED WARRANTY

RW Flame RFH-6001LH Specifications

General IconGeneral
ModelRFH-6001LH
TypeElectric Fireplace
Fuel TypeElectric
Heating Power1500W
Remote ControlYes
Safety FeaturesOverheat Protection
MountingFreestanding
Heating CoverageUp to 400 sq ft
MaterialMetal, Glass
Flame EffectLED
ThermostatAdjustable
TimerYes

Related product manuals