4. Operation
The RxAir air purifier is easy to operate.
Position the unit on a flat floor surface.
Plug the flat end of the power supply
cord into the inset located in the rear left
corner of the unt and then insert the
inverse side of the power supply cord
into a 120V electrical outlet.
Warning!
Ensure proper ground before use.
Figure 2: Power Cord Warning
A properly installed electrical outlet is an essential part of overall safety. If you have any
questions as to the status of the electrical power outlet please call a qualified electrical
contractor.
The unit may then be turned on by pressing the POWER switch at which time the ON
indicator light will illuminate and the blower and UV system will operate. Select blower
speed High or Low by pressing the BLOWER switch and the indicator will change
accordingly.
The REPLACE UV BULB indicator will flash if the sensor detects a non-functioning UV
lamp. Note: See also section 6.4.
The REPLACE FILTER indicator will be on if the sensor detects low air flow through the
filter. Note: The HEPA Filter requires replacement if the indicator lamp is on.
To Next Page
Loading...