ryan REN-O-THIN 544865B - 10 Decals

10 DECALS
12
R
DECALS
3. RESET REAR AXLE POSITION IF PROPER HEIGHT CANNOT BE OBTAINED
OPERATING INSTRUCTIONS
BEFORE OPERATING
522390
OPERATION
1. CHECK FOR LOOSE, DAMAGED OR MISSING PARTS. REPAIR BEFORE
OPERATING MACHINE.
2. ADJUST BLADE HEIGHT TO 1/8” (3MM) OFF GROUND WHEN MACHINE IS
PARKED ON HARD LEVEL SURFACE.
WITH THE FRONT ADJUSTER.
1. STAND BEHIND HANDLEBAR. PULL CONTROL BAIL BACK TO HANDLEBAR
AND HOLD TO ENGAGE REEL.
2. RESET BLADE HEIGHT AS NECESSARY TO OBTAIN DESIRED RAKING DEPTH
3. STOP REEL WHEN TURNING AROUND AND CROSSING HARD SURFACES
OR OBSTRUCTIONS.
4. IF ENGINE STARTS TO BOG DOWN, REDUCE WALKING SPEED AND/OR
PUSH DOWN ON HANDLEBAR TO LIFT REEL SLIGHTLY UNTIL ENGINE
RECOVERS.
522394
FAILURE TO HEED THESE WARNINGS MAY RESULT IN PERSONAL OR FATAL
INJURY TO YOU OR OTHERS AND MAY ALSO RESULT IN EQUIPMENT AND/OR
PROPERTY DAMAGE
WARNING
KNIVES, AND DRIVE BELTS. STOP REEL OR RAISE AERATING TINES
AND KNIVES BEFORE CROSSING SIDEWALKS OR OTHER HARD SURFACES.
IT IS YOUR RESPOSIBILITY TO KEEP ALL LABELS (DECALS) AND
INSTRUCTIONAL LITERATURE LEGIBLE AND INTACT. REPLACEMENT
LABELS (DECALS) AND LITERATURE ARE AVAILABLE FROM THE FACTORY.
READ, STUDY AND UNDERSTAND ALL WARNING LABELS AND OPERATING
INSTRUCTIONS FURNISHED WITH THIS EQUIPMENT PRIOR TO USE. IF
ANY PART OF THIS MATERIAL IS UNCLEAR, CONTACT YOUR FACTORY
REPRESENTATIVE FOR CLARIFICATION. NEVER ALLOW UNSKILLED OR
IMPROPERLY TRAINED PERSONNEL TO OPERATE THIS EQUIPMENT.
BEFORE SERVICING, OR MAKING ADJUSTMENTS, STOP ENGINE. NEVER
OPERATE EQUIPMENT WITHOUT GUARDS/SHIELDS IN PLACE. KEEP
HANDS AND FEET AWAY FROM ROTATING BLADES, AERATING TINES AND
13
12
11
1
2
3
4
5
6
7
8
9
10
520913
RAISE
REEL
LOWER
REEL
R
REN–O–THIN
1
2
3
4
5
6
R
E
E
L
D
S
N
G
A
G
I
E
E
N
G
A
G
E
E
520912
7
8