ryan REN-O-THIN 544865B - Specifications

IDENTIFICATION 2
1
2 IDENTIFICATION
The Model Number and Serial Number are printed on the
nameplate decal located on the back of the chassis (see
Figure 1). These numbers must appear on all
correspondence concerning this unit.
1
FIGURE 1
1. Nameplate Decal
3 SPECIFICATIONS
Chassis 12 gauge steel, formed and welded. . . . . . . .
Reduction 1.33:1 (engine to reel). . . . . . . . . . . . . . . . .
Wheelbase 14 5/8” (371 mm) at level position. . . . . . .
Reel Speed 2700 RPM. . . . . . . . . . . . . . . . . . . . . . . . . .
Cutting Width 18” (457 mm). . . . . . . . . . . . . . . . . . . . . .
Cutting Depth 7/8” (22 mm). . . . . . . . . . . . . . . . . . . . . .
Blade Adjustment 1” (25 mm) above ground level. . .
to 7/8” (22 mm) below ground level
Weight (less reel) 106 lbs. (48 Kg.). . . . . . . . . . . . . . .
Engine 6.5 h.p. Briggs and Stratton. . . . . . . . . . . . . .
model no. 121432 type 0120 trim E1,
four cycle, aluminum cylinder with cast
iron sleeve, 3600 RPM governor– no
load, recoil starter.