Installation
11
4. Installation
WARNINGS
●
THE FOLLOWING INSTRUCTIONS ARE INTENDED TO GIVE YOU A BRIEF
GUIDANCE FOR INSTALLATION.
●
Dropping your TOMBO 360 unit or subjecting it to excessive
shock and
vibrations as this may cause it to malfunction and is not covered by
warranty.
warranty.
● The TOMBO 360 unit IS NOT WATERPROOF. Avoid exposing it to rain or
other forms of excessive moisture. Water damage is not covered under the
warranty.
●
Most vehicles have the mirror mounted directly onto the glass, therefore
improper tools or techniques used in the installation could result in a
damaged or broken windshield. Rydeen is not responsible for damages to
windshield caused by installation processes.
DIY Installation
(For TOMBO 360 standard package)
Step 1
Use the
provided
Velcro straps
and
insert between
the rear slots of the TOMBO 360.
Paste the adhesive provided
in
the position as shown in the picture below. This will
prevent vibration and protect the original rear-view mirror from being scratched. Loop
the Velcro straps around the original mirror and tighten down the strap.
To Next Page
Loading...
