Ryobi BS901 - Included Parts and Required Tools; Loose Parts Identification; Tools for Assembly and Adjustment

Page 8
Check all loose parts from the box with the list below. Assemble according to the instructions on the following pages.
3 mm Hex Key .............................................. 1
4 mm Hex Key .............................................. 1
5 mm Hex Key .............................................. 1
Miter Gauge .................................................. 1
Saw Table ..................................................... 1
Table Lock Handle ........................................ 1
Washer.......................................................... 1
Operator’s Manual (not shown) .................... 1
LOOSE PARTS LIST
Fig. 2
5 mm HEX KEY
MITER GAUGE
4 mm HEX KEY
The following tools (not included) are needed for checking adjustments of your saw or for installing the blade:
Adjustable Wrench
Combination Square
Phillips Screwdriver
TOOLS NEEDED
PHILLIPS SCREWDRIVER
COMBINATION
SQUARE
ADJUSTABLE WRENCH
3 mm HEX KEY
SAW TABLE
TABLE LOCK HANDLE
WASHER
30
45
60
75
9
0
7
5
6
0
4
5
3
0