Ryobi RLT254CDSO - Starting a Cold Engine by Electrical Starter

22
OPERATION
1
2
1
2
x10
1
2
1
2
3
STARTING A COLD ENGINE BY
ELECTRICAL STARTER
1. Install the starter bit into the electrical starter
with the pentagon bit facing outside. Push
the F/R button to the left until the pentagon
symbol shows on the F/R button.
2. Insert the battery pack into the electrical
starter until it clicks into place.
WARNING: Keep your hands away from
the starter bit to avoid injury.
3. Lay the product on the ground, press the
primer bulb 10 times, and then set to
choke position.
NOTE : The fuel should be visible in the
primer bulb after the 7th press.