Ryobi RLT254CDSO - Page 25

23
OPERATION
1
2
4s
VI
4s
VI
4
3
1
2
3
4s
VI
4s
VI
4
4
5
1
2
6
1
2
7
4. Hold down the throttle lock and squeeze the
throttle trigger (through step 6). Put the starter
bit shaft to the shaft hole on the engine.
Press and hold the electrical starter switch
button until the engine attempts to start. Do
not press the electrical starter for more than
4 seconds.
5. Set to choke position. Press and hold the
electrical starter switch button until the engine
starts.
NOTE : If the engine does not start, repeat the
procedure again from step 3
6. Allow the engine to run for 10 seconds, and
then set the lever to position.
7. Hold down the throttle lock and then squeeze
the throttle trigger to start using the product.