Why does oil drip from the silencer of my Ryobi RLT26CDS Trimmer?
Oil may drip from the silencer of your Ryobi Trimmer if you are operating the trimmer at partial throttle (operate the trimmer at full throttle), the oil/fuel mixture is incorrect (use fresh fuel and the correct synthetic 2-stroke oil mix), or the air filter is dirty (clean per instruction in "Maintenance" section).
What should I do if grass wraps around the shaft housing and bump head of my Ryobi Trimmer?
If grass wraps around the shaft housing and bump head of your Ryobi Trimmer, it may be because you are cutting tall grass at ground level (cut tall grass from the top down) or operating the trimmer at partial throttle (operate the trimmer at full throttle).
What to do if my Ryobi Trimmer engine starts but won't idle long enough to engage throttle?
Temperature can affect the engine idle time and RPM. Flip the choke lever to the position indicated and pull the starter until the engine starts.
Why does my Ryobi RLT26CDS Trimmer engine start but not accelerate?
The engine of your Ryobi Trimmer may require approximately three minutes to warm up. Allow the engine to completely warm up. If the engine does not accelerate after three minutes, contact a servicing dealer.
Why does my Ryobi RLT26CDS Trimmer engine not reach full speed and emits excessive smoke?
If your Ryobi Trimmer engine isn't reaching full speed and is emitting excessive smoke: * Check the oil fuel mixture. Use fresh fuel and the correct 2-stroke oil mix. * The air filter might be dirty. Clean the air filter. * The spark arrestor screen might be dirty, contact a servicing dealer.
What to do if my Ryobi Trimmer engine does not stop when I turn it off?
Set the choke lever to stop the engine. Immediately stop using the product. Check the electrical connection on the bottom of the trimmer and make sure it is properly connected. Contact a servicing dealer if the problem persists.
Why does my Ryobi RLT26CDS Trimmer engine not reach full speed and emit excessive smoke?
The Ryobi Trimmer engine might not reach full speed and emit excessive smoke because the oil fuel mixture is incorrect (use fresh fuel and the correct 2-stroke oil mix), or the air filter is dirty (clean the air filter). Contact a servicing dealer if the spark arrestor screen is dirty.
What to do if the line will not advance on my Ryobi RLT26CDS?
If the line on your Ryobi Trimmer won't advance, it could be due to several reasons. The line might be welded to itself (lubricate with silicone spray), there might not be enough line on the spool (install more line), the line might be worn too short (pull the lines while pressing down on and releasing the bump head), the line might be tangled on the spool (remove and rewind the line), or the engine speed might be too slow (advance the line at full throttle).
Explains signal words and their meanings to clarify risk levels associated with the product.
Specific instructions for storing the product for less than one month.
Instructions for unpacking the product and checking contents.
Procedure for attaching the front handle to the trimmer.
Instructions for handling fuel and refueling the trimmer safely.
Procedures for starting and stopping the grass trimmer engine.
Details on how to operate the trimmer effectively and safely.
General| Power source | - |
|---|---|
| Line diameter | 2.4 mm |
| Product color | Green |
| Cutting diameter (max) | 430 mm |
Weight and Dimensions| Weight | 4300 g |
|---|
To Next Page
