Ryobi RLT26CDSE - OPERATION; STARTING A COLD ENGINE; STARTING A WARM ENGINE; OPERATING THE TRIMMER

12
OPERATION
4
1
2
3
IV
4x
10
4
1
2
3
IV
6x
2
3
2
x10x10
1
1
STARTING A COLD ENGINE
1. Press the primer bulb 10 times. Set the
choke lever to “Full” position.
2. Keep the throttle trigger squeezed completely
through steps 2 to 4 and pull the starter grip
until the engine attempts to start. Do not pull
the starter grip more than 4 times. Set the
choke lever to “half” position.
3. Pull the starter grip until the engine starts. Do
not pull the starter grip more than 6 times.
Allow the engine to run for 10 seconds
4. Set the choke lever to “Run” position.
44
66
4