SAB F450 - Unpack

Automatic Backflush Filter F450
State: 05.02.2016 – 1.3 Georg Schünemann GmbH, Bremen 4-2
4.2 Unpack
Before beginning see

chapter 1 „Safety“ and

chapter 4.1 „Before installation“ in this chapter
Crush hazard!
The weights of the automatic backflush filter F450, the cover assembly and the
strainer insert you will see in the acceptance report. During transport and the
assembly, crush injuries of the fingers, hands and/or the feet could happen.
An adequate safety clearance has to be kept.

Protect the automatic backflush filter F450 during transport, assembly and
disassembly against slipping and falling down.

Only use suitable technical proper lifting tools with sufficient load capacity.

Wear safety footwear.
Before unpacking the filter the following rules have to be considered:
Never lift the filter at the pneumatic cylinder,
only on the flanges with lifting belt safety
against slipping.
Example
Check:

the automatic backflush filter F450 for outside damages,

the connections on damages,

the flanges for soiling.
Remove the possible existing transport locks or flange catches.
Do not install the automatic backflush filter F450, if it is damaged.
Clean possible contamination.