Automatic Backflush Filter F450
State: 05.02.2016 – 1.3 Georg Schünemann GmbH, Bremen 0-2
0.2 Table of contents
0 Scope 0-1
0.1 Structure and use of the operation manual 0-1
0.2 Table of contents 0-2
0.3 List of illustrations 0-4
0.4 List of tables 0-4
0.5 List of abbreviations 0-4
0.6 Intended and improper use 0-5
0.7 Necessary diligence of the operator 0-6
0.8 Qualification and education of staff 0-7
0.9 Liability 0-8
1 Safety 1-1
1.1 Symbols 1-1
1.2 Basic safety instructions 1-2
1.3 Accident prevention rules 1-5
1.3.1 General 1-5
1.3.2 Assembly and disassembly 1-5
1.3.3 Transport/Location 1-5
1.3.4 Electrical system 1-6
1.3.5 Compressed air system 1-6
1.3.6 Safety at setting out of operation 1-7
1.3.7 Maintenance and repair 1-7
1.4 Operation 1-8
2 Description 2-1
2.1 General description 2-1
2.2 Technical description 2-1
2.2.1 Description of the operational functions 2-2
2.2.2 Control of the automatic backflush filter F450 2-4
3 General data 3-1
3.1 Signs and name plates 3-1
3.2 Sound emission 3-2
4 Installation and setting to work 4-1
4.1 Before installation 4-1
4.2 Unpack 4-2
4.3 Installation 4-3
4.4 Steps for setting into operation 4-5
4.5 Setting into operation 4-6
4.6 Testing and adjusting of the operating parameters 4-7
4.6.1 Switch on control with the power switch, first flushing phase/pre-flushing
check 4-7
4.6.2 Setting the running time of the pneumatic cylinder to operating
conditions, second flushing phase / filtration 4-7
4.6.3 Check of proper terminating of flushing 4-8
4.6.4 Adjustment of flushing interval T1 at the electronic control 4-8
4.6.5 Optional: Lead time for flushing T4 and flushing valve end position
control T5 (throttle time) 4-8
4.6.6 Adjustment of time and date 4-9
4.6.7 Operating parameter 4-9
5 Service and operation 5-1
To Next Page
Loading...