Saba LVSL4915X - Unsatisfactory Washing Result

Problem Possible Causes What To Do
General
problems
Suds in the
tub
Improper detergent
Use only the special dishwasher
detergent to avoid suds�
If this occurs, open the dishwasher
and let suds evaporate Add 1 gallon of
cold water to the tub� Close and latch
the dishwasher, then select any cycle�
Dishwasher will drain out the water
at the rst step� Open the door after
draining is stop and check if the suds is
disappeared�
Repeat if necessary�
Spilled rinse-aid
Always wipe up rinse-aid spills
immediately�
Stained tub
interior
Detergent with colourant
was used
Make sure that the detergent is the one
without colourant�
White lm
on inside
surface
Hard water minerals
To clean the interior, use a damp
sponge with dishwasher detergent
and wear rubber gloves� Never use
any other cleaner than dishwasher
detergent for the risk of foaming or
suds�
There are
rust stains on
cutlery
The aected items are
not corrosion resistant�
A programme was not
run after dishwasher salt
was added�
Traces of salt have gotten
into the wash cycle�
Always run the quick wash programme�
without any crockery in the dishwasher
and without selecting the Turbo
function (if present), after adding
dishwasher salt�
The lid of the softer is
loose�
Check the lip �Ensure the x is ne�
Problem Possible Causes What To Do
Noise
Knocking
noise in
the wash
cabinet
A spray arm is knocking
against an item in a
basket
Interrupt the programme, and
rearrange the items which are
obstructing the spray arm�
Rattling
noise in
the wash
cabinet
Items of crockery are
loose in the wash
cabinet
Interrupt the programme, and
rearrange the items of crockery�
Knocking
noise in the
water pipes
This may be caused by
on-site installation or
the cross-section of the
piping�
This has no inuence on the dishwasher
function� if in doubt, contact a suitably
qualied plumber�
Unsatisfactory
washing
result
The dishes
are not
clean
The dishes were not
loaded correctly�
See notes in “Loading the Dishwasher
Baskets”�
The programme was
not powerful enough�
Select a more intensive programme�
See “Wash Cycle Table”�
Not enough detergent
was dispensed�
Use more detergent, or change your
detergent�
Items are blocking the
path of spray arms�
Rearrange the items so that the spray
can rotate freely�
The lter combination
in the base of wash
cabinet is not clean or is
not correctly tted� This
may cause the spray
arm jets to get blocked�
Clean and/or t the lter combination
correctly� Clean the spray arm jets� See
“Cleaning the Spray Arms”�
111110
GB GB