Sabo 43-COMPACT - Engine Performance Decreases; Engine Runs Irregularly; Extreme Vibration

18
GB
Start-up takes longer than 5 seconds
or is repeated too often (only for
electro-start).
If you experience start difficulties, contrary
to expectations, the battery must also be
charged in between.
Connection cable between the
ignition key, battery and engine is
loose or without contact (only for
electro-start).
Connect the battery connector with the
mating connector on the harness U1 or
check it or have it checked by an authorised
workshop.
Engine performance decreases
Air filter dirty.
Clean or replace air filter insert W .
Spark plug contaminated with soot.
Have it cleaned by an authorized dealer.
Engine runs irregularly
Air filter dirty.
Clean or replace air filter insert W .
Spark plug contaminated with soot.
Have it cleaned by an authorized dealer.
Have it checked by an authorized dealer.
Extreme vibration
Have it checked by an authorized dealer
Unclean cut, lawn is yellow
Blade blunt.
Have it sharpened and balanced by an
authorized dealer Q .
Cutting height too low.
Adjust to higher cutting height I .
Engine speed too low.
Operate at max. rpm.
Mowing too fast.
Adjust mowing speed.
Insufficient overlapping of cuts when
mowing.
Tall grass conditions may dictate that more
overlapping of cuts is required.
Lawn becomes matted.
A lawn scarifier can remedy the problem
considerably
Ejection blocked
Turbo signal has not been detected
J + K .
Empty the grass collector L .
Engine speed too low.
Operate at max. rpm.
Cutting height too low for grass that
is too high.
Adjust to higher cutting height I .
Pushing mower too fast.
Adjust mowing speed.
Grass not dry.
Let grass dry.
Mulched grass appearance is
poor:
clumps, excessive clippings,
rough cut.
Blade blunt.
Have it sharpened and balanced by an
authorized dealer.
Mulching rule not followed (cut max.
1/3 of the grass height; the height of
the grass to be cut must be lower
than 10 cm)
Adjust to higher cutting height I .
Convert mower to rear discharge U2 +
S1 and mow grass first with higher cutting
setting.
Travel speed too fast.
Adjust travel speed.
Grass build-up under deck.
Adjust to higher cutting height I .
Insufficient overlapping of cuts when
mowing.
Tall grass conditions may dictate that more
overlapping of cuts is required
Grass not dry.
Adjust to higher cutting height I .
Let grass dry.
In case of faults and defects which have not been listed here, please contact the nearest authorized dealer.
Repairs which require specialized knowledge should only be performed by a qualified expert. Your authorized dealer will
naturally also be glad to help if you do not wish to perform the maintenance work described here yourself.