Operating manual - ChillPAC and LP ChillPAC Mk 3
16/68
010823 en 2021.06
Safety
The compressor name plate is positioned on the compressor and contains this information:
Compressor no.
Identification no. (serial no).
Year
Year of manufacturing.
Type Manufacturer's type designation.
Refrigerant
Allowable refrigerant or refrigerants for the compressor.
(The actual refrigerant for the unit is stated on the unit name plate).
Speed
Specific rotational speed. Specific rotational speed is used for calculat-
ing swept volume. For the actual allowed operating speed, please refer
to the operating limits and Matchmaster's calculation on the actual op-
erating condition.
Swept volume Swept volume of the compressor at nominal speed.
Pressure system
The low-pressure side of the compressor is referred to as the LP side.
The high-pressure side of the compressor is referred to as the HP
side.
Allowable pressure, max.
The max. pressure (pressure relative to atmospheric pressure) that
the compressor has been designed for in terms of pressure strength
design.
The maximum practical operation pressure is lower than the maximum
allowable pressure, depending on the operating conditions and safety
equipment settings.
Test pressure The test pressure the compressor has been strength tested with.
CE and Ex
The CE and Ex marks indicate that the compressor has been designed
in accordance with the EC ATEX directive.
EAC
The EurAsian Conformity mark (EAC) indicates that the compressor is
in compliance with all relevant technical regulations of the Eurasian
Customs Union.
To Next Page
Loading...