Saeco Incanto HD8917 - Troubleshooting Filters; AquaClean Filter Troubleshooting

Problem Cause Solution
I cannot activate the
AquaClean lter and
the machine asks for
descaling.
You have already replaced
the AquaClean lter 8 times.
After you have replaced the
AquaClean lter 8 times, you
need to descale the machine.
Descale your machine rst and
install the AquaClean lter.
Always activate the AquaClean
lter in the menu. Also do this
when you replace the lter.
The lter has not been replaced
in time after the AquaClean lter
icon ashed and the capacity
dropped to 0%.
Descale your machine rst and
then install the AquaClean
lter.
You did not install the
AquaClean lter during rst
installation, but after having
brewed approx. 50 coees
(based on 100ml cups). The
machine has to be completely
limescale-free before you install
the AquaClean lter.
First descale the machine and
then install a new AquaClean
lter. After descaling, the lter
counter is reset to 0/8. Always
conrm lter activation in the
machine menu. Also do this
after lter replacement.
You did not activate the new
or replaced AquaClean lter in
the machine menu. Also after
replacing the lter, you need to
conrm activation in the machine
menu.
Descale your machine rst.
Then activate the AquaClean
lter in the menu. Also do this
when you replace the lter.
The AquaClean lter
icon does not appear
on the display after I
replaced the lter.
You did not conrm activation in
the machine menu.
Conrm the activation of the
lter in the machine menu.
If the display shows 'START
CALC CLEAN', you rst need
to descale the machine.
Remove the AquaClean lter
before descaling and reinsert it
afterwards.
The AquaClean lter
is installed, but the
descaling message
appears.
You have not activated the
AquaClean lter in the machine
menu.
First descale the machine and
then install a new AquaClean
lter. This will reset the lter
counter to 0/8. Always
conrm lter activation in the
machine menu, also after lter
replacement.
The AquaClean lter
does not t.
You need to remove air from the
lter.
Let air bubbles come out of
the lter.
There is still water in the water
tank.
Empty the water tank before
you install the lter.
You are trying to install another
lter than the AquaClean lter.
Only the AquaClean lter ts
into the machine.
You need to remove air
from the lter.
The rubber o-ring is not attached
to the AquaClean lter.
Check the packaging for the
o-ring and attach it to the
AquaClean lter.
English
37
4219_460_3631_2_Lux_Booklet_A5_v2.indd 37 21/07/17 14:30