English
8
31
DISPLAY Description
1.3.5.
Enables management of the "Remaining Qty" countdown.
Important
From the maintenance menu (button P2 on the CPU), you can access "Water Filter", "Last Filter
Change", "Remaining Qty" and "Filter Reset".
Filter enabled
yes
1.4.
According to the model, the Phedra vending machine may be equipped with 1 or 2 boilers.
The following "BOILERS TABLE" matches the boilers with the vending machine models.
This menu option allows setting the operating temperature of boiler 1.
Boiler 1 temp.
1.4.1.
It allows you to set the temperature that the vending machine keeps for a few minutes after a
beverage has been brewed.
The set value is expressed in centigrade.
Min. Temperature
00
1.4.2.
It allows you to assign the temperature to which the vending machine is brought after a certain time
from the last dispensing, so that the natural lowering of the temperature of the hydraulic circuits
can be compensated.
The set value is expressed in centigrade.
Max. Temperature
000
1.5.
Enables selecting the vending machine's operation under no water conditions.
If NO (default) is selected, the vending machine works as if it were connected to the water network
and tries to refill water every 10 minutes as usual.
If "YES" is set, the VM works as if it were supplied by an independent tank. Indeed, in no water
condition, the vending machine does not try to refill water and goes into ERROR 01.
Water tank
1.6.
The “Stand-by” and “ECO” modes allow reducing the energy consumption of the machine.
It is possible to select one or both modes.
Energy save
…
1.6.1.
The “Stand-by” mode is activated after some minutes of inactivity which can be set by means of this
menu option. By setting it to zero the function is disabled.
In“Stand-by” mode the coffee and steam boilers are turned off (instant product boiler remains on)
and the display shows the message “Stand-by”.
To exit the “Stand-by” mode, press any button or insert some credit.
When normal operation is restored, the boilers are turned on and the vending machine starts the
warm-up phase.
Stand-by timeout
1.7.
This menu allows setting the parameters related to the the preheating operations for the brew
group, the brewing circuits for instant products or the steam dispensing circuit.
Preheating
1.7.1.
It allows enabling a pre-heating cycle of the Brew Group if it remains inactive for a period of time.
This menu allows setting the minutes of inactivity after which the pre-heating cycle has to take place.
The settable values are:
0 (zero) pre-heating cycle disabled,
from 60 seconds to 900 seconds at intervals of 60.
The default value is 300.
Coffee preheating
00
1.8.
By setting the “W” value in the product list, hot water will be dispensed.
This menu allows choosing the solenoid valve to be used for dispensing
If the “hot water solenoid valve” kit is installed, set the value to 0 (zero) or select the solenoid valve
operating on the desired circuit among the available ones.
EV Water Assign
…
1.9.
Rinsing time
1.9.1.
It allows enabling of the automatic rinsing of the mixing bowls.
The automatic rinsing is performed as follows: the first rinsing takes place 10 minutes after the
“machine ready” status; if necessary, other rinses occur 7 hours after the last dispensing.
Rinsing cycle
yes
1.10. Enables instant pre-grinding of the coffee dose.
Pre-grinding
yes
To Next Page
Loading...
