45
ENGLISH
45
Yellow
2
Remove the Automatic Milk Frother from the hot water/steam wand.
3
Remove the “INTENZA+” water lter from the water tank if it was in-
stalled and replace it with the small white original one. Place the water
tank back into the machine.
4
Press the “ ” button until the following display is shown.
5
Press the “ ” button to start the descaling process.
Yellow
Note:
If you press the “
” button by mistake, press the “ ” button to quit.
6
Remove the water tank and pour the entire content of the Descaling
solution. Then ll the water tank with fresh water up to the calc clean
level.
7
Place the water tank back into the machine.
8
Place a large container (1.5L) under both the steam/hot water wand
and the dispensing spout.
To Next Page
Loading...
