English
5
76
Make a 100 mm Ø hole on the surface (hole A in the figure).
Install the machine in its final position on the supporting
surface (the rings B indicate the ideal position of the
adjustable feet).
Level the machine by setting the adjustable feet.
FR Machine front side
A Hole to be made
B Ideal position of the adjustable feet
5.3 Connection to the Water
Network
Before connecting the
appliance to the water
network, please read and
follow the applicable
regulations in force in your
country.
Make sure the water
network provides drinking
water, with pressure
ranging between 0.15 MPA
and 0.8 MPA (1.5 and 8
bars).
Water hardness should not
be lower than 8°F.
Screw the drain pipe assembly at the base of the frame as
shown in the figure.
Insert the drip tray into the machine front.
To Next Page
Loading...
