USER MANUAL - SIP POWER ION PUMP CONTROLLER
M.HIST.0109.23 Rev.1 Page 2 of 62
The SIP POWER power supply is used for operating the ION element of NEXTorr family pumps. It
is designed to be used indoor in laboratory conditions.
Security provisions
Symbols on the Product
These symbols appear on the product:
WARNING
High voltage
Ground terminal
CAUTION
Refer to manual
WARNING
After transportation, the device has to be left idle without mains
voltage for at least 3 hours at the laboratory temperature.
ATTENTION
Inside the instrument and also in the connector and cable for the
ion pump connection, a high voltage is present which is capable of
causing a casualty even without any direct touch.
Manipulation of the high voltage cable and also of the
grounding wire is prohibited during the supply operation.
Likewise, the supply operation without protective covers is
prohibited.
Protect the device against humidity and against penetration of
conductive objects and liquids into the ventilation slots.
To Next Page
Loading...
Need help?
General
