USER MANUAL - SIP POWER ION PUMP CONTROLLER
M.HIST.0109.23 Rev.1 Page 21 of 62
A / V / W key can select among current / voltage / power values
Torr / Pa / mb key converts the pressure unit of measurement to Torr / Pascal / mbar;
moreover pressing this latter key for a long period deletes all the notifications on display.
SETTING page
The functions of each key are shown above and below them.
To enter and exit SETTING menu press at the same time central and right keys for 5 seconds
Use the keys or to run through the menu
To modify a parameter press ENTER; a blinking cursor will indicate the parameter change
mode. In order to modify the parameter act on keys or .
A short pressure increments/decrements the value by 1 unit, a long pressure will make the
values change quickly, the longer the pressure, the faster the change.
Press ENTER to save and make a value active.
For multifield parameters ENTER will switch from one field to the next and saving will only
happen when all field will be modified.
In order to leave SETTING menu, press at the same time central and right keys for 5 seconds
For details on all setting see SETTINGS chapter.
To Next Page
Loading...
Need help?
General
