SAGEMCOM RM50 - Getting Started; Initial Device Setup

11
Getting Started
2. Getting Started
2.1 Turning On The Device for The First Time
Please confirm that your wireless router or Access Point (AP) is connected to
the broadband network. The diagram below describes the network
environment that should be established to use your IP Radio.
Internet
DSL/ Cable Modem
Wireless
Router
5V DC
RAUDI O L
5V DC
(1) Plug the included power adapter into a wall outlet.
(2) Connect the power adapter to the power jack on the rear panel of the
device.
(3) Press and hold the Power button on the rear panel to turn on the device.
2.1.2 Setting Up The device
2.1.1 Network Environment