4.5 Network config
4.5.1 Scan For Networks
4.5.2 View Config
As mentioned in the chapter Turning On The Device For The First Time, the
device will automatically connect to the set network each time the device is
turned on.
However, if you need to configure the network settings for your IP Radio, you will
be able to do that in this section.
Please refer to the chapter Turning On The Device For The First Time for details.
In this section, you can view your network information. If you need to configure
the settings, please refer to Edit config. section for details.
4.4.3 Volume limitation
If you select volume limitation to On, when you adjust the volume, it will not
increase till the loudest but to a certain volume limit. This helps to prevent a
sudden loud sound.
Rotate the Wheel to choose On or Off and press the Wheel to activate.
To Next Page
Loading...
Need help?
General