Sailmon MAX - Install Add-ons; Connect Windsensor

MAX QUICK START GUIDE 25
5. INSTALL ADDONS
Due to the Bluetooth connection in MAX, you have the possibility to
connect wireless add-ons. These add-ons will provide you with more
data during sailing (on MAX) and afterwards (in the Sailmon App):
- Ultrasonic Wind Sensor (TWA, TWD, TWS, AWA, AWS)
- Cyclops Marine loadcells (loadcell)
- NMEA 0183/2000 (Speed, depth and wind)
FIND OUT MORE | Do you want to SEE instead of read how you can connect the add-ons
to MAX? Check out the video tutorials on sailmon.com/max/support
WINDSENSOR
Add the Ultrasonic Windsensor to add TWA, TWD, TWS, AWA and AWS to
your MAX and the Sailmon App.
1. Go to Menu > System > Sensors > Wind > Connect Wind Sensor
2. Place the Windsensor very close to your MAX.
The MAX will automatically detect the Windsensor
3. Does your MAX show ‘Found Device’?
Connect (click on right top button)
4. Does your MAX show ‘Receiving Data’? Exit the page
5. Place your Windsensor at a fixed place on your boat. Make sure to
point the small mark on the Windsensor forwards.
DEVICE : number of device
CONNECTED : YES or NO
UPDATE COUNTER : shows incoming data from windsensor
RAW AWS : Raw Apparent Wind Angle relative to boat/
windsensor
RAW AWA : Raw Apparent Wind Speed relative to boat/
windsensor