MAX QUICK START GUIDE 27
LOADCELL
Add the wireless Loadcells to add loadcells to your MAX and
the Sailmon App.
1. Go to Menu > System > Sensors > Loadcell
2. Place the Loadcell very close to your MAX. Make sure it is in ‘high
power mode’. The MAX will automatically detect the Loadcell.
3. Does your MAX show ‘Found Device’?
Connect (click on right top button)
4. Does your MAX show ‘Receiving Data’? Exit the page
5. Place your Windsensor at a fixed place on your boat
DEVICE : serial number of MAX unit
CONNECTED : YES or NO
UPDATE COUNTER : shows incoming data from loadcell
LOAD : shows current load in KG of loadcell
NMEA
Add the wireless NMEA 0183 or 2000 to add speed, depth and wind to
your MAX and the Sailmon App.
1. Go to Menu > System > Sensors > Set UDP Input Port
2. Fill in the UDP input port number 60001 and press save
3. Go to network, choose w2k and fill in password (on actisense)
To Next Page
Loading...