24
Detail
4.11 Software releases
4.11.1 Radio software release
The RT5022/RT5020 running software version can be read out from menu 4.6.1.1. The
version information displayed is partitioned into three sections:
• Main Release X.YY.zz. Bundled sample software release tag. Will follow host
processor software tag.
• Version X.YY.zz (DSP). Sub-version for the audio DSP image.
• Version X.YY.zz (BM). Boot monitor version.
The indices are explained as the following:
• Index X is increased if major product updates are required - e.g. introduction of a
new radio model. Requires certificate update if increased.
• Index YY is increased if major feature update or serious bugs are implemented.
Requires certificate update if increased.
• Index zz. This index is increased if small software changes are made during product
life-time. For a new version the index will start as X.YY.00; small changes will add up
ie.e X.YY.01, X.YY.02 etc. For software releases with only the zz index increased,
Notified Body will be “informed” only, without the need for updating the certificate until
next X.YY.00 release is at stake. If zz equals 00 it might be omitted in the display.
4.11.2 Remote control unit software release
The CU5000 accessory units software can be read out the following way:
1. Turn off the CU.
2. Hold down [DIM] and [CH^] while turning the CU on (pressing [ON]).
3. The SW version (Xy) is shown in the display (as long as [ON] is
pressed).
The version is partitioned in two sections:
• Digit X. Major release update. Certificate update required if increased.
• Digit y. This digit is increased if small software changes are made during product life-
time. For a new version the index will start as X0; small changes will add up ie.e X1,
X2 etc. For software releases with only the y index increased, Notified Body will be
“informed” only, without the need for updating the certificate until next X0 release is
at stake.
0605
To Next Page
Loading...
Need help?
General
