79
Signalling high-beam
head-lamps
To use the signalling high-beam
headlamps pull the control lamp
lever toward yourself as shown
in the gure and then release to
return it to its initial position.
When signalling by high-beam
headlamps, it is not necessary
to set the lamps in ON position
Turn signal lamps
To turn on the turn signal lamps,
the ignition switch must be set in
ON position.
As shown in the gure, when
turning right push up the control
lever and when turning left push
down it.
The signal lever includes two
stages:
First stage - This stage is related
to changing line and passing the
vehicle in front of you.
Second stage
- This stage is related to the full
displacement of the lever when
turning left or right. It returns to
its initial position after complete
steering wheel turn. If the turn
signal lamps stay on after
turning, return the lever to its
initial position manually.
OWM082
OWM083
4
Lamps
To Next Page
