4.3.2 Mounting Procedures
The battery employs either ground mounting or wall mounting and its position is determined by the drilled
holes of bracket.
Ground Mounting
The ground should be flat and no inclination.
Step 1: Assemble the base. Adjust the height of foot cup, make sure the surface of base is horizontal.
Figure 4.4
Assembling the base
Step 2: Place the base on the ground, make sure the edge of base is 27mm away from wall. Place the battery
module on the base and secure it with screws (M4*10).
Figure 4.5
Securing the battery
Step 3: Stack the rest of the battery modules up and secure the battery modules with locking brackets by
screws (M4*10)
Figure 4.6
Securing battery modules
with locking brackets
Step 4: After the battery modules installation, mark the proper positions of battery control unit and drill holes
(13mm in diameter, 65mm in depth) on those positions by using the battery control unit as a template. Remove
the rubber feet for the top battery module before installing battery control unit.
Figure 4.7
Drilling holes to install
Battery control unit
To Next Page
Loading...