PREPARATION
2.1 Safety Instructions
For safety, be sure to read all the safety instructions carefully prior to any works, and please observe the
appropriate rules and regulations of the country or region where you installed B2 battery.
·Please keep the power off prior to any operations
·Do not use the battery or the battery control unit if it is defective, broken or damaged.
·Do not expose the battery to temperatures in excess of 50°C.
·Do not subject the battery to any strong force.
·Do not place the battery near a heat source, such as direct sunlight, a fireplace.
·Keep inflammable and explosive dangerous items or flames away from the battery.
·Do not soak the battery in water or expose it to moisture or liquids.
·Do not use the battery in vehicles.
·Do not use the battery in areas where the ammonia content of the air exceeds 20ppm.
·Only qualified personnel who has full knowledge of local safety regulations and local standards on battery can install,
maintain, retrieve and process this product.
·SAJ electric shall not be liable for any loss or warranty claims arising from any unauthorized change of product which may
cause fatal injury to the operator, third party or equipment performance.
·For personal and property safety, do not short-circuit the positive (+) and negative (-) electrode terminals.
·Do not modify or change any components in the battery.
·Risk of damage due to improper modification
·Use professional tools when operating the products.
·During installation of the battery B2 high voltage battery, circuit breaker must be disconnected from the battery pack wiring.
·The battery B2 can only be used as a set with SAJ's H2 high voltage series storage inverter, otherwise it cannot be used
normally.
To Next Page
Loading...
Need help?
General
