6.4.3 Inverter Setting Review
After commissioning, the device info including device basic info, running info and event info can be viewed.
Country and grid code can be viewed from initial setting.
6.5 Working Modes
6.5.1 Selecting Working Modes Procedures
6.5.2 Working Modes Introduction
Self-consumption Mode: When the solar is sufficient, electricity generated by photovoltaic
system will be supplied to load first, the surplus energy will be stored in battery, then the
excess electricity will be exported to the grid. When the solar is insufficient, the battery will
release electricity to supply load.
Back-up Mode: Reserved Backup SOC setting value can be adjusted, when battery SOC is
less than reserved SOC value, battery can only be charged, until SOC reaches reserved value,
the battery will be stopped charging; when SOC is larger than SOC setting value, battery will
behave as Self-use mode.
To Next Page
Loading...
Need help?
General
