To Next PageTo Next Page
Need help?Do you have a question about the SAJ HS2 Series and is the answer not in the manual?
General| Battery Type | Lithium-ion |
|---|---|
| Nominal Battery Voltage | 48 V |
| Protection Level | IP65 |
| Interface | CAN, RS485 |
| RAID Support | No |
| Operating Temperature | -20°C to 60°C |
| Humidity | 0~95 % |
Defines the manual's scope for specific SAJ products.
Provides critical safety warnings and guidelines for operation.
Specifies qualified personnel for installation and maintenance.
Detailed safety precautions for handling the system.
Explains various warning and informational symbols used in the manual.
Guidelines for safe and proper handling of the battery modules.
Recommended actions for emergency scenarios involving the battery.
Describes the intended use of the product in residential PV systems.
Explains the naming convention for HS2/AS2 product models.
Provides dimensions and a visual overview of the HS2/AS2 inverter and battery.
Details the interface ports and terminals on HS2 and AS2 units.
Presents technical specifications and parameters for the inverter and battery.
Guides on checking the package contents and condition upon delivery.
Details suitable locations and clearance requirements for installation.
Step-by-step guide on physically mounting the system components.
Lists recommended tools required for installation.
Details on connecting an extra grounding cable for safety.
Procedures for connecting AC grid and backup output wires.
Guidance on installing AC circuit breakers and RCDs.
Instructions for connecting the PV array to the inverter.
How to establish communication links for monitoring and control.
Steps for connecting the communication cable between batteries and inverter.
Procedures for connecting the high-voltage battery power cables.
Diagrams illustrating system wiring for different regions.
Visual representation of HS2 and AS2 system wiring configurations.
Explanation of the Arc-Fault Circuit Interrupter (AFCI) function.
Procedures for starting and stopping the system.
Overview of the LED indicators and system status.
Steps to perform the initial system setup and configuration.
Guide to connecting and using the eSAJ mobile application.
Instructions for establishing a local connection via Bluetooth or Wi-Fi.
Explanation of different operational modes and their settings.
How to configure export limits for grid-tied operation.
Instructions for performing the self-test function as per Italian standards.
Configuration for reactive power control according to Australian regulations.
Guidelines for safely transporting the product.
Recommendations for storing the product when not in use.
Lists fault codes and their corresponding information.
Information on warranty conditions and terms.
