SAJ R5-3.6K-S2 - Page 18

R5 Series
- 17 -
Figure 4.4 Dimensions of rear panel of R5-7K/8K-S2
4.4.2 Drill Holes and Place the Expansion Tubes
According to the guides, drill 3 holes in the wall (in conformity with position
marked in Figure 4.5), and then place expansion tubes in the holes using a rubber
mallet.
Figure 4.5 Drill holes’ dimensions of R5-3K/3.6K/4K/5K/6K/7K/8K-S2
4.4.3 Mount the Screws and the Rear Panel
The panels should be mounted in the mounting position by screws as shown in
Figure 4.6.