Sako V780 - Page 54

48
PC Multi-Reference and Simple PLC Function
Function
Code
Parameter
Name
Setting Range Default Property
PC-00 Reference 0 -100.0% ～ 100.0% 0.0% ☆
PC-01 Reference 1 -100.0% ～ 100.0% 0.0% ☆
PC-02 Reference 2 -100.0% ～ 100.0% 0.0% ☆
PC-03 Reference 3 -100.0% ～ 100.0% 0.0% ☆
PC-04 Reference 4 -100.0% ～ 100.0% 0.0% ☆
PC-05 Reference 5 -100.0% ～ 100.0% 0.0% ☆
PC-06 Reference 6 -100.0% ～ 100.0% 0.0% ☆
PC-07 Reference 7 -100.0% ～ 100.0% 0.0% ☆
PC-08 Reference 8 -100.0% ～ 100.0% 0.0% ☆
PC-09 Reference 9 -100.0% ～ 100.0% 0.0% ☆
PC-10 Reference 10 -100.0% ～ 100.0% 0.0% ☆
PC-11 Reference 11 -100.0% ～ 100.0% 0.0% ☆
PC-12 Reference 12 -100.0% ～ 100.0% 0.0% ☆
PC-13 Reference 13 -100.0% ～ 100.0% 0.0% ☆
PC-14 Reference 14 -100.0% ～ 100.0% 0.0% ☆
PC-15 Reference 15 -100.0% ～ 100.0% 0.0% ☆
PC-16
Simple PLC
running
mode
0: Stop after the AC drive runs one cycle
1: Keep 󽗉nal values after the AC drive
runs one cycle
2: Repeat after the AC drive runs one
cycle
0 ☆
6.1 Brief introduction of function code