Sako V780 - Page 55

49
PC Multi-Reference and Simple PLC Function
Function
Code
Parameter
Name
Setting Range Default Property
PC-17 Simple PLC retentive selection
Unit's digit (Retentive
upon power failure)
0: No
1: Yes
Ten's digit (Retentive
upon stop)
0: No
1: Yes
00 ☆
PC-18
Running time of simple PLC
reference 0
0.0s(h) ～ 6553.5s(h) 0.0s(h) ☆
PC-19
Acceleration/deceleration
time of simple PLC reference 0
0 ～ 3 0 ☆
PC-20
Running time of simple PLC
reference 1
0.0s(h) ～ 6553.5s(h) 0.0s(h) ☆
PC-21
Acceleration/deceleration
time of simple PLC reference 1
0 ～ 3 0 ☆
PC-22
Running time of simple PLC
reference 2
0.0s(h) ～ 6553.5s(h) 0.0s(h) ☆
PC-23
Acceleration/deceleration
time of simple PLC reference 2
0 ～ 3 0 ☆
PC-24
Running time of simple PLC
reference 3
0.0s(h) ～ 6553.5s(h) 0.0s(h) ☆
PC-25
Acceleration/deceleration
time of simple PLC reference 3
0 ～ 3 0 ☆
PC-26
Running time of simple PLC
reference 4
0.0s(h) ～ 6553.5s(h) 0.0s(h) ☆
PC-27
Acceleration/deceleration
time of simple PLC reference 4
0 ～ 3 0 ☆
6.1 Brief introduction of function code