Sako V780 - Page 64

58
U0 Monitoring Parameters
Function
Code
Parameter
Name
Setting
Range
Default Property
U0-24 Linear speed 1m/Min ●
U0-25 Accumulative power-on time 1Min ●
U0-26 Accumulative running time 0.1Min ●
U0-27 HDI pulse input frequency 1Hz ●
U0-28 Communication setting value 0.01% ●
U0-30 Main frequency X 0.01Hz ●
U0-31 Auxiliary frequency Y 0.01Hz ●
U0-32 Viewing any register address value 1 ●
U0-35 Target torque (%) 0.1% ●
U0-36 Rotation postion 1 ●
U0-37 Power factor angle 0.1° ●
U0-39 Target voltage upon V/F separation 1V ●
U0-40 Output voltage upon V/F separation 1V ●
U0-41 DI state visual display 1 ●
U0-42 DO state visual display 1 ●
U0-43 DI function state visual display 1(function 01-40) 1 ●
U0-44 DI function state visual display 2(function 41-80) 1 ●
U0-45 Fault information 1 ●
U0-59 Current set frequency(%) 0.01% ●
U0-60 Current running frequency(%) 0.01% ●
U0-61 AC drive running state 1 ●
U0-62 Current fault code 1 ●
U0-65 Torque upper limit 0.1% ●
6.1 Brief introduction of function code